Wind Veer Rate Calculated Column

This calculated data column will contain the wind veer rate for every time step of the dataset. The dataset must contain direction data measured at two or more different measurement heights.

Note that default flag filtering applies to these calculations. The number of direction sensors involved in the calculation will vary from one time step to the next depending on which sensors report valid measurements in each time step. In a time step where Windographer cannot calculate the veer rate because of insufficient data, the wind veer rate calculated column will have a gap.

Like it does for all calculated data columns, Windographer will re-calculate the wind veer rate calculated column whenever you change any of the source data columns, for example by flagging or deleting a segment, applying a scale factor, or appending more data.

See also

Wind veer rate

Calculated data column


Written by: Tom Lambert
Contact: windographer.support@ul.com
Last modified: November 13, 2017